Variable Powerhead Profile Outlet

[RamsReef]

Hello,

My program does not seem to be working the way I thought it would, suggestions please.
I want it to Flush the last 2 minutes of every hour, however, it just goes into flush mode, and does not OSC.


Set Wave4_Feed
If Time 00:00 to 08:00 Then Wave2_Swell
If Time 08:00 to 18:00 Then Wave1_Pulse
If Time 18:00 to 23:59 Then Wave2_Swell
OSC 58:00/2:00/0:00 Then Wave3_Flush
If FeedA 000 Then Wave4_Feed
If FeedD 000 Then OFF

 

[Joe Grubbs]

Hello,

I believe that your difficulty is arising from the order of your commands. Remember that the Last active command in the stack "wins". I suspect if you move your OSC command to the top of the If Time commands you'll get the result you are looking for.

Set Wave4_Feed
OSC 58:00/2:00/0:00 Then Wave3_Flush
If Time 00:00 to 08:00 Then Wave2_Swell
If Time 08:00 to 18:00 Then Wave1_Pulse
If Time 18:00 to 23:59 Then Wave2_Swell
If FeedA 000 Then Wave4_Feed
If FeedD 000 Then OFF

 

[RamsReef]

No this would never work then as flush has to be last. What you have to do is make a virtual outlet that contains the osc command.

Then on the pump you say

If outlet (your outlet) on then (flush profile)

This works

 

[RamsReef]

Here

Fallback Wave1_PulL
Set Wave6_FeedL
If Time 00:00 to 08:00 Then Wave3_SwelL
If Time 08:00 to 18:00 Then Wave1_PulL
If Time 18:00 to 23:59 Then Wave3_SwelL
If Outlet PH_FLUSH = ON Then Wave5_Stir
If FeedA 000 Then Wave6_FeedL
If FeedD 000 Then OFF