Vecta pumps dead.

[XNavyDiver]

I've got two vectra m1 pumps and neither will work. There is something wrong with the drivers. The drive knob starts out in green, the pump sounds like it's trying to start then the drive knob flashes red, then the whole useless cycle starts over again. I've tried unplugging, hard re set, nothing works. It won't even start a calibration.

 

[PmCarbrey]

is it flashing just red? red and green? red and white?

 

[XNavyDiver]

Starts off solid green, flashes red then back to solid green...white with the led level meter going all the way, then back to green.

 

[PmCarbrey]

Your pump is stalling. Take it out and see if there is anything obstructing the impeller or if there is calcium buildup on the shaft obstructing it from spooling up properly.

 

[XNavyDiver]

 

[XNavyDiver]

Your pump is stalling. Take it out and see if there is anything obstructing the impeller or if there is calcium buildup on the shaft obstructing it from spooling up properly.

Already did that. Pump and plumbing clear.

 

[PmCarbrey]

hmm looks like you've got a driver issue. Try this, the video is for an mp10, but the process is the same: