Vectra S2 way too strong even when set to lowest setting

[Roman'sReef]

So i have a red sea reefer 350 and initially set the flow to 1% which ik is too low but this is irrelevant rn the flow being output was definitely 1% now altough it says 1% and on the controller i cant scroll the wheel lower the flow is like 50% how do i lower the wattage? or am i doing smth wrong? Help!

 

[blaxsun]

There's no way it would be 50% at one quarter power.

 

[Roman'sReef]

There's no way it would be 50% at one quarter power.

Dw thx but its fixed it was like that before but had to calibrate it thats all

 

[blaxsun]

Dw thx but its fixed it was like that before but had to calibrate it thats all

Ah, well - glad you were able to figure it out. Yeah, the Vectras do need to go through that initial calibration (not like most pumps where you just set the speed and go!)

 

[Sisterlimonpot]

So i have a red sea reefer 350 and initially set the flow to 1% which ik is too low but this is irrelevant rn the flow being output was definitely 1% now altough it says 1% and on the controller i cant scroll the wheel lower the flow is like 50% how do i lower the wattage? or am i doing smth wrong? Help!

Have you calibrated the minimum and maximum flow?

Seems to me that it's possible that the wrong calibration is limiting you from lowering the flow below the minimum set during calibration.

 

[Roman'sReef]

Have you calibrated the minimum and maximum flow?

Seems to me that it's possible that the wrong calibration is limiting you from lowering the flow below the minimum set during

Have you calibrated the minimum and maximum flow?

Seems to me that it's possible that the wrong calibration is limiting you from lowering the flow below the minimum set during calibration.

Thank you calibrating was the fix

 

[Sisterlimonpot]

Thank you calibrating was the fix

You figured it out before I could type it out. Haha