ok so how do you property align it, and how does not properly aligning it break the ceramic piece, I mean you put the wet up against the dry, turn unit on and spin slowly until noise stops, we’ll my noise never stops them when I take apart to see the ceramic piece Si broken off, so please tell me what I’m doing wrong.
This is true even a few millimeters off will cause them to separate and fall off
That's how I do it. I have speed set very low. Turn it on and feel for vibration or hear noise then make micro adjustments in the alignment. Do this after I remove them to clean glass. Dirty glass can affect also.
Dry and wet side separation and falling off.
The wet isn’t falling off the dry, it’s a 2nd wet that the ceramic piece is breaking off and is noisy the same thing happens to my first piece, the wet was attached to the dry since I put it on last night.
Is there vibration?
I’m aware of that also I’m using the right spacer I’m using the thin one because my glass is under 1/2 but over 1/4 see pic the yellow is where my glass ends
