Waterbox 2.75” Filter media cup

[Fettie05]

I recently got a waterbox aio 28.2 frag tank. I was looking to find filter media cups to swap out for the socks the tank uses, due to the fact they are only 2.75” wide with a hard plastic ring these things are a pain in the neck to turn inside out an clean. Iv looked online, no luck probably not out there, was looking to see if some one found any or maybe some one can 3D print something. TIA

 

[ingchr1]

I wasn't able to find one either. I did see a post on the Waterbox Aquariums Official Group Facebook page where someone was working on a 3D printed one.

I posted this up on a similar thread in the Waterbox vendor section:

You could use the inTank filter floss holders for the Cube 10, 15 and 20. That's what I just changed my 40.2 over to.

They aren't made specifically for the tank, but just cut the floss to the size of the chamber. No issues.

Here's a link showing them in my tank build thread: https://www.reef2reef.com/index.php?posts/6336751

 

[Fettie05]

I wasn't able to find one either. I did see a post on the Waterbox Aquariums Official Group Facebook page where someone was working on a 3D printed one.

I posted this up on a similar thread in the Waterbox vendor section:

You could use the inTank filter floss holders for the Cube 10, 15 and 20. That's what I just changed my 40.2 over to.

They aren't made specifically for the tank, but just cut the floss to the size of the chamber. No issues.

Here's a link showing them in my tank build thread: https://www.reef2reef.com/index.php?posts/6336751

Thanks. I was thinking about using what you have but I felt it was small for the area but seems like that’s the option for now till I can have some made

 

[gotblur]

I got one from OCTO Aquatics (https://www.reef2reef.com/threads/octo-cup™.362873/). Fits perfect and I'm sure this is what you are looking for.