Wxm module help

[CNDReef]

I bought a used wxm and i can’t seam to pair it with my apex jr or the mp10.
The status light is on but the wireless light just keeps blinking.
Any help would be great

 

[Bob Escher]

Did you go and check to see if it’s listed on the web interface?
Did you reboot the system

 

[CNDReef]

Rebooted and it comes up on the system Under modules on display and on aqua controller but not in fusion

 

[CNDReef]

 

[Bob Escher]

The module itself doesn’t show up in fusion now you need to attach eithervthe pumps or lights
It may not do it right away so do it a couple times if it doesn’t make sure you update the firmware as well

 

[CNDReef]

I’ve tried a bunch of times
How would you do it , if you don’t mind?

 

[Bob Escher]

You have the pumps
If so you have to do it on the pump your pumps are wireless
If so then you’ll need to read the ecotech pump manual
I haven’t read it in a while
If you have a radion light you do it on the Apex web interface as is shown

 

[CNDReef]

Still no go
I think it’s got something to do with the wireless part of the wxm since that light keeps blinking

 

[Bob Escher]

So it wasn’t able to connect ? Do you see the women module in web version

 

[CNDReef]

It comes up on the classic dashboard , mp10 blinks blue /yellow meaning it’s connected but the outlets don’t come up

 

[CNDReef]

Only thing that I can see wrong is the wireless light blinking instead of being steady

 

[Bob Escher]

Have you used the controls on the MP10 to connect it I don’t remember how to do it

 

[CNDReef]

Yup and they say if it flashes blue/ yellow it’s connected

 

[CNDReef]

Hold Mode/set
Hold mode
Hold set
Then
Hold mode/set
Tap set
If it flashes blue/yellow it’s connected
If red/blue it’s not

 

[CNDReef]

I read on Neptune’s page to make sure that both lights are steady yellow but they don’t give you a option for if they aren’t lol

 

[Bob Escher]

Ok did you unlock fusion and see if the pump was in their

 

[CNDReef]

Under the locked tiles? Yes and nothing there. I wonder if there’s anything else interfering with the signal

 

[Bob Escher]

Did you scroll all the way across

 

[jonmos75]

You have an issue with the echotech wireless chip. It is no longer working pictured below
(It is not showing a revision number or RF channel. )

You can try to update the wireless chip, but most likely it will need to get replaced.
Be patient this can take longer then 5 minutes and if disrupted before it finishes typically ends bad and gives what you are currently seeing on your WXM.
(I am not saying this is how you got your WXM in this state)

 

[CNDReef]

You have an issue with the echotech wireless chip. It is no longer working pictured below
(It is not showing a revision number or RF channel. )

You can try to update the wireless chip, but most likely it will need to get replaced.
Be patient this can take longer then 5 minutes and if disrupted before it finishes typically ends bad and gives what you are currently seeing on your WXM.
(I am not saying this is how you got your WXM in this state)

I’ll try that
Does it tell you when it’s finished?