Dialing in dose

[Anirban]

Ok its time to start the components. Do you have ready made ones or you prepare them.

 

[ken77]

I have both. Prepared one arebon doser now but hust got in jugs of 123.

 

[ken77]

I was thinking it might be best to start with the ready made so i had ordered some.

 

[Anirban]

Ok, we will go with the readymade ones. Ok, 60 ml total of each component split over the day at least 4 dose. So, 15 ml per dose. Measure parameters at night and let me know.

 

[ken77]

Should i start now and work all the doses in before normal test time tonight. Then after test readjust the time to spread it over a 24 hr period after that?

 

[ken77]

Ok to change my cabon and phosphate - i havent changed anything since we stopped dosing pump and put water changes on hold.

 

[Anirban]

Dont change the carbon and GFO today do it on tuesday. Just start the dosing now and measure the parameters at night. You dont need to complete the whole schedule.

 

[ken77]

Ok thanks drilling holes in container tops now to get started

 

[ken77]

Ok so here is tonights winning numbers jk. First off i hope i dint mess us up but Ca was 430 this morning. I had a typo when i put it into apex fusion this morning i hit .24 not .14
I think my doser probably only dosed two cycle so 20mls before i tested tonight. I set it up for 10 mls 6 times a day.
Alk 7.34
Ca 415
Mg 1470

 

[Anirban]

Ok so here is tonights winning numbers jk. First off i hope i dint mess us up but Ca was 430 this morning. I had a typo when i put it into apex fusion this morning i hit .24 not .14
I think my doser probably only dosed two cycle so 20mls before i tested tonight. I set it up for 10 mls 6 times a day.
Alk 7.34
Ca 415
Mg 1470

So these are current numbers right?

 

[ken77]

Yeah tested right before i posted them

 

[ken77]

Yeah i tested right before i posted them.

 

[Anirban]

Are you sure the Mg is 1470? It increased 60 ppm from morning while your Alk and Ca both dropped.

 

[ken77]

Let me chech it again

 

[ken77]

You were right i got 1425

 

[Anirban]

You were right i got 1425

Be careful with the measurements or else we have to go back again. Add 80 ml of Alk now and if there is no problem then measure the Alk tomorrow morning just to be safe. Let it sit there for 24 hour and let me know the reading tomorrow night.

 

[ken77]

Yeah that would be horrible.
Leave the doser on right?

 

[Anirban]

Yes ...

 

[ken77]

Ok i will check it in the morning and let you know tomorrow night.
Thanks for all your help

 

[Anirban]

Dont forget to add the Alk tonight.