homemade automatic KH Tester With Opensource.

[Filamin]

Hey @SHARK_2 would you be willing to share the PCB design so people can order it? Would be awesome =)

 

[insidethesquare]

Hi Axlzys. I cannot log into the software. I have completed to installation. I can see the rasberry pi on my network with the correct ip address (192.168.1.90). When I type the ip address is does not work.

What am I doing wrong?

Thanks,

Dilshan

 

[SDchris]

Hey Dilshan,
I haven't used it, but just checking if you updated the wpa_supplicant.conf file?

 

[insidethesquare]

Hi Chris,

I did update the wpa-supplicant file. I can see it on the router with the right ip address. I am also accessing it with my computer ip being 192.168.1.x. It does not load the homepage. I think I will try re-wiring it again because apprently it does not work if it is not wired correctly, although I can see the LED is illuminated on the pH circuit board. The trials and tribullations of DIY . I will let you know if I get it working.

 

[yusufhadiwinata]

Hi Chris,

I did update the wpa-supplicant file. I can see it on the router with the right ip address. I am also accessing it with my computer ip being 192.168.1.x. It does not load the homepage. I think I will try re-wiring it again because apprently it does not work if it is not wired correctly, although I can see the LED is illuminated on the pH circuit board. The trials and tribullations of DIY . I will let you know if I get it working.

can you try to use Port 5000 ? 192.168.1.x:5000
or try to telnet port 5000 / ssh to 192.168.1.x