Programing The ApexEL

Gary Ellis · Mar 8, 2020

Well, it took a while. I'm a little slow. I want to Thank You very very much for your help and time. I would have never figured it out myself. Thanks again.

Gary Ellis · Mar 8, 2020

SuncrestReef said:
You must leave the output sliders set to AUTO in order for the Apex to follow the programming. If you move the slider to ON or OFF, those are manual settings and the Apex will ignore the programmed rules.

If you’re new to Apex programming, you might benefit from reading my 8-part Apex programming tutorial series: https://www.reef2reef.com/ams/authors/suncrestreef.93940/

Thanks, will do.

Mical · Mar 8, 2020

Gary Ellis said:
Well, it took a while. I'm a little slow. I want to Thank You very very much for your help and time. I would have never figured it out myself. Thanks again.

Nah, you're not slow. Apex programming has a slight learning curve to it. I've been harping on BRS to do an actual hands on "step by step" video of Ryan and/or Randy setting up a basic apex set up. From unboxing to mounting to actual programming. It would quadruple their sales and take all the mystery of Apex programming away. All the current videos available (BRS' & Neptunes) are scattered and are so abbreviated that it just adds to the confusion and scares potential customers away. @randyBRS any input?

Gary Ellis · Mar 8, 2020

Yes, vids for programming would be a good idea.

Mical · Mar 8, 2020

Gary Ellis said:
Yes, vids for programming would be a good idea.

There's a TON of videos out there about Apex's, problem is the majority of them assume you know the basics about them. I got a crash course when I decided to control 2 tanks on one controller. I was told you could do that but NO-ONE went into details.

I'm actually astonished that Neptune or any of the retailers have not done a basic set-up video in detail. Terrance @ Neptune does the "it takes 10 minutes to set up" (no offense @Terence ) but for a potential new customer it's like learning a new language. It's like learning how to wire a GCFI outlet "here's the box, electrical tape & a screwdriver - have at it".