- Joined
- Sep 20, 2021
- Messages
- 769
- Reaction score
- 770
- Location
- Australia, NSW, Sydney.
- What state or country do you live in
- Australia
I found a way to make an emergency filter or heater from home materials. If they fail and you cant go to the fish store at the second, This is the tread for you!
what will you need:
water siphon.
filter media (any type)
small container
the 1st one I will do it the backup filter.
Backup filter:
1.
grab your siphon, add filter media in the outtake of the siphon, make sure the filter media is at the outtake like this:
2. grab small container, add filter media to container like this. Try and make it so the water travels through the container, here's an example, you can use any filter media:
next, place the intake of the siphon at the bottom or the aquarium, make sure the intake is at the bottom of the tank, you may need to weigh down the intake. Put your small container at the surface of the tank so that when the water exits the siphon, it goes into the container and overflows and re-enters your tank like this, the image below is just above the tank so the water can overflow back into the tank:
above is what it should look like when its finished. It may take a while for the water to compress and for the siphon flow to start. Good luck! If this doesn't work for you or you want to correct it please tell me.
Heater:
What you will need:
A container
A kettle
1. Add hot water to a kettle, add the hot water to the bottle, place the bottle in the tank and monitor temperature to make sure the hot bottle doesn't over heat the tank.
Im begging you to correct me if im wrong, PLEASE! Thank you everyone.

what will you need:
water siphon.
filter media (any type)
small container
the 1st one I will do it the backup filter.
Backup filter:
1.
grab your siphon, add filter media in the outtake of the siphon, make sure the filter media is at the outtake like this:
2. grab small container, add filter media to container like this. Try and make it so the water travels through the container, here's an example, you can use any filter media:
next, place the intake of the siphon at the bottom or the aquarium, make sure the intake is at the bottom of the tank, you may need to weigh down the intake. Put your small container at the surface of the tank so that when the water exits the siphon, it goes into the container and overflows and re-enters your tank like this, the image below is just above the tank so the water can overflow back into the tank:
above is what it should look like when its finished. It may take a while for the water to compress and for the siphon flow to start. Good luck! If this doesn't work for you or you want to correct it please tell me.
Heater:
What you will need:
A container
A kettle
1. Add hot water to a kettle, add the hot water to the bottle, place the bottle in the tank and monitor temperature to make sure the hot bottle doesn't over heat the tank.
Im begging you to correct me if im wrong, PLEASE! Thank you everyone.






