Can someone reccomend me an rodi system

Karliefish · Nov 19, 2020

Saltyreef said:
Yes spectrapure has a c02 test kit.

All you would need is a brute trash can or similar container (how ever much water you'd like to make in a 24 -48hr period)
A maxi jet 1200 pump
Airstone with pump
Home made adapter, 1/2" threaded coupler with a 1/2" thread x 1/2" push to connect on one side and a 1/2" thread x 1/4" push to connect on the other to connect RO tubing to the pump reliably.

RO discharges into brute can until full.
Airate and mix overnight or longer.
Connect adapter to maxi jet pump and connect the output to the inlet of your DI canisters.

Cheap home made degassing system

ahhh I get it now, very clear and helpful. I assume all I have to do is search for c02 test kit on Spectrapure website?
So if I'm using a Spectrpure RODI system, I want to discharge the water into some sort of container prior to water being pushed through the DI canisters. Is that after canister one or two on a Spectrapure setup? would wouldn't have picture of the parts required here?

I'm trying to figure out how hard this is going to be given that I need to make 400 gallons of water. and will be making 40-80 galllons everyweek. Praying that I don't have a Co2 problem

THANK YOU SO MUCH!

Fishyfish22 · Nov 19, 2020

Brs makes good ones.

I personally use a kent marine one that came with the first tank I purchased back in 2011. I think it was used for a few years before then as well. Over the years added a water saver upgrade kit, flush kit, auto water stopper, an inline TDS meter and its been going strong the whole time!

Just keep up with membrane/filter replacements and you'll be good to go

Straasha · Nov 19, 2020

I purchased the Aquaticlife 4 stage system and have been happy with it.
AquaticLife

Saltyreef · Nov 19, 2020

Karliefish said:
ahhh I get it now, very clear and helpful. I assume all I have to do is search for c02 test kit on Spectrapure website?
So if I'm using a Spectrpure RODI system, I want to discharge the water into some sort of container prior to water being pushed through the DI canisters. Is that after canister one or two on a Spectrapure setup? would wouldn't have picture of the parts required here?

I'm trying to figure out how hard this is going to be given that I need to make 400 gallons of water. and will be making 40-80 galllons everyweek. Praying that I don't have a Co2 problem
THANK YOU SO MUCH!

Yes and no problem.
The RO you want to offgas prior to introducing to the DI stages.
Heres the c02 kit