Jebao Products?

jebao products are good espeically their powerhead.
very affordable and reliable.
 
Only thing that I had issues with was the stock controllers for my RW's. They NEVER stayed in sync. I just recently replaced them with a JB wave controller and couldn't be happier now.
 
I have 2 RW15s in my 120g. I have them hooked up to and run them through my controller. They are great. You can purchase the RW/PP4 through Amazon or Fish Street. I think Fish Street prices are lower, but you don't get a warranty. The powerheads aren't high end price wise and people do have functionality issues with them every now and then, but they perform incredibly high end and are incredibly inexpensive.


Do you have the pp15 at highest flow rate or turned down? I also have a 120 4'x2'x2' mixed reef half plus being SPS and am debating between 2 PP8's or 2 PP15's.
 
I'm running them through my Vertex Cerebra in a long sine wave pattern where the pumps ramp up from 35% to 100% in an alternating fashion. I have a deep 4 inch sand bed made of sugar sized grains and don't have any issues with the sand blowing around. I do have a lot of rock work covering my sand bed.

Get the 15s. The 8s are too small for a 120. If I had a six foot tank, I'd be using the 20s.
 
Use Jebaos myself after another Reefer turned me on to them. Definitely see a difference in power consumption Jebao use less. Like the ramp up start up and feed functions.
I have twin 8000 in my filter on my 175 and bleed off both of them one for a 36 Watt UV and the other for a pair of sand filters. No issues with quality (running for a year now) and as stated just keep them clean. I do feel that they are a little light on the calculations for lift.
 
Vortech over jebeo. But if your on a tight budget they get the job done. Just don't expect them to last 5 years. None of my jebeo power heads have made it longer than a year.
 
Does anyone where to buy the replacement bushes for my CP40 as shown below. It got damaged i was running it by glueing them but I am sure it will not go for a long. If any one knows how to get replacement please revert.
WP_20161211_001.jpg
WP_20161211_003.jpg
 
Yeah, go to FishStreet.com and look for the custom order link. You let them know what you need and they reply back if they can do it and what it will cost.
 
Good Luck!

Hi thank you,
I have contacted both fish street and Jecod customer. Now both of them are sending the spare rubber to me. Of course I have to pay for fish street and for Jecod I have to pay only the courier expense. Hope to get the same by next week. Very good response from both of them.
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 32 45.7%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 12.9%
  • No.

    Votes: 26 37.1%
  • Other (please explain).

    Votes: 3 4.3%

New Posts

Back
Top